Features

This page lists what the platform can do today. What cannot be computed yet is not listed here.

For all machine types

Requirements sheet

Operating points, peak run with duration and start temperature, envelope, temperature limits, cooling.

Scout

Comparison of suitable topologies in figures; an expert can also set the topology directly.

Basic design

Template parameters, cross-section, traffic light against the requirements, dependent dimensions follow.

Studies

Field computation, efficiency and loss maps, thermal network, rotor strength.

3D model

The whole machine with end windings and standard parts, with masses per part and a longitudinal section.

Report and export

Results with their basis as a report; geometry and data for further processing.

AI assistant

Ask, check, create variants and start optimisations, with the cost before every computation.

Programming interface

Everything the interface can do is also available through the API, for your scripts and your own AI tool.

Per machine type

PMSM with buried V magnets

  • Inner rotor

Permanent-magnet synchronous machine with magnets in V-shaped pockets, the standard in traction drives.

  • Distributed winding or tooth coils, round wire or hairpin bars
  • Rotor laid out for overspeed, bridges and corner radii checked by stress analysis
  • Transient field computation with cogging torque, harmonics and eddy-current losses in the magnets
  • Cooling by water jacket, oil spray, hollow shaft and oil channels in the back iron

PMSM with surface magnets

  • Inner rotor
  • Outer rotor

Magnets on the rotor surface, as an inner rotor with a sleeve or as an outer rotor.

  • Inner rotor with sleeve, outer rotor with magnets on the rotor yoke
  • Distributed winding or tooth coils
  • Strength of magnets and sleeve under centrifugal load
  • Magnet losses from harmonics in the field computation

Synchronous reluctance machine

  • Inner rotor

Rotor with flux barriers and no magnets; torque comes from the difference of the inductances.

  • Flux barriers in two to four layers with bridges and ribs
  • Best current angle per operating point, power factor as a key figure
  • Strength of bridges and ribs under centrifugal load

Induction machine with cage

  • Inner rotor

Rotor with a copper or aluminium cage and no magnets; torque through slip.

  • Cage of copper or aluminium, rotor slot shape selectable
  • Time-harmonic field computation over slip, maps from a family of such computations
  • Operation at the voltage and current limit
  • Cage losses in the thermal network

Wound-field synchronous machine

  • Inner rotor

Rotor with salient poles and field coils and no magnets; the field current is the third control variable.

  • A field coil per pole, fed through slip rings and brushes
  • Field current, d- and q-axis current per operating point for the lowest losses
  • Limits of field current, field voltage and field winding temperature
  • Strength of the pole shoe with the coils as load under centrifugal force